Standby Timers - Cisco Catalyst 6500 Series Command Reference Manual

Ssl services module command reference
Hide thumbs Also See for Catalyst 6500 Series:
Table of Contents

Advertisement

Chapter 2
Commands for the Catalyst 6500 Series SSL Services Module

standby timers

To configure the time between hello packets and the time before other routers declare the active hot
standby or standby router to be down, use the standby timers command. Use the no form of this
command to return to the default settings.
Syntax Description
group-number
msec
hellotime
holdtime
Defaults
The defaults are as follows:
Command Modes
Subinterface configuration submode
Command History
Release
SSL Services Module
Release 2.1(1)
SSL Services Module
Release 3.1(1)
Usage Guidelines
The valid values for hellotime are as follows:
The valid values for holdtime are as follows:
If you specify the msec keyword, the hello interval is in milliseconds. Millisecond timers allow for faster
failover.
OL-9105-01
standby [group-number] timers [msec] hellotime [msec] holdtime
no standby [group-number] timers [msec] hellotime [msec] holdtime
(Optional) Group number on the interface to which the timers apply.
(Optional) Specifies the interval in milliseconds.
Hello interval (in seconds); see the "Usage Guidelines" section for valid
values.
Time (in seconds) before the active or standby router is declared to be down;
see the "Usage Guidelines" section for valid values.
group-number is 0.
hellotime is 3 seconds.
holdtime is 10 seconds.
Modification
Support for this command was introduced on the Catalyst 6500 series
switches.
The command mode for this command was changed from Proxy-VLAN to
Subinterface.
If you did not enter the msec keyword, valid values are from 1 to 254 seconds.
If you enter the msec keyword, valid values are from 15 to 999 milliseconds.
If you did not enter the msec keyword, valid values are from x to 255 seconds, where x is the
hellotime and 50 milliseconds and is rounded up to the nearest 1 second.
If you enter the msec keyword, valid values are from y to 3000 milliseconds, where y is greater than
or equal to 3 times the hellotime and is not less than 50 milliseconds.
Catalyst 6500 Series Switch SSL Services Module Command Reference
standby timers
2-111

Advertisement

Table of Contents
loading

Table of Contents