Denon AVR-X3300W Service Manual page 108

3-6 GUI (ADV8003) failure detection procedure
Check item(60).
Rewrite to the GUI ROM.
After writing, is the GUI version readable cor-
rectly?
NO
Checking device. (GUI)
Check the I2C communication line. (GUI)
Check item (61). Check communication between CPU and the
HDMI Tx device.
Send the following command from Termite.exe.
Send the command "i 001A 00D0 0002".
Is the return value "6082" ?
If the communication results are not OK
If the communication results are OK
Check item(62).
Replace the GUI Rom(U1027).
Is the GUI version readable correctly?
NO
Check item(63).
Replace the GUI(U1026).
Is the GUI version readable correctly?
NO
Replace the PCB.
YES
Go to check item (3)
Example
i 001A 00D0 0002
6082
If it is normal, "6082" is returned.
Go to check item (64)
YES
Go to check item (3)
YES
Go to check item (3)
When the results of check item (61) are "the communication results are not OK"
Checking device. (GUI)
Check the power supply voltage. (GUI)
Check item(64). Check the power supply voltage.
:
Does the GUI (U1026) power voltage indicate an
appropriate voltage (1.8V or 3.3V)?
The test points are as follows.
1.8V
3.3V
U1026
YES
The GUI (U1026) is faulty.
Replace with a new device.
Recheck from check item (1).
If it does not work, replace the PCB.
108
NO Check item(65). Check the power supply voltage.
:
Check the power supply components
Q1063/Q1055) on the substrate and peripheral
pattern.
If there is no problem, remove the GUI (U1026)
from the substrate and measure the voltage at
the test point of check item (64).
Is the voltage correct (1.8 V or 3.3 V)?
YES NO
The power supply circuit is faulty.
Replace the PCB.
Go to next page.
(U1069/