RH Baby&child INDUSTRIAL PIPE SINGLE DESK Assembly Instructions

PARTS INCLUDED
A [2] BENT PIPE
B [1] TABLE TOP
C [2] LONG SHELF
D [2] SHORT PIPE
E [2] SOLID ROD WITH THREAD ON BOTH ENDS
TOOLS NEEDED
A [1] PHILLIPS-HEAD SCREWDRIVER (not provided)
HARDWARE LIST
DESCRIPTION
NO. ITEM
Phillips Screws Long
1
2 Plastic Anchor
Phillips Screw Short
3
Step 2
B
G
B
Step 3
G
G
F
B
RH BABY&CHILD
INDUSTRIAL PIPE SINGLE DESK – ASSEMBLY INSTRUCTIONS
F [2] FRONT LEG
G [2] BACK LEG
H [2] LONG PIPE
QTY.
8 pcs.
8 pcs.
8 pcs.
G
3
G
G
B
F
B
G
F
G
F
B
Page 1 of 3
IMPORTANT SAFETY INSTRUCTIONS :
• These products are not compatible with baseboards.
• Young children may be injured by tipping furniture. Proper installation
of the mounting hardware for this item is highly recommended. When
properly installed, the anti-tipping hardware could provide proteection
against the unexpected tipping of this furniture piece.
ASSEMBLY INSTRUCTIONS
TWO OR MORE PEOPLE MAY BE NEEDED FOR EASY ASSEMBLY
1. Carefully unpack the contents of the carton and position the pieces in
the location where the finished product will sit.
2. Set the Table Top (B) upside down on a soft, clean surface. Attach one
Back Leg (G) by placing the leg inside the specified groove and fixing it
in place with four Phillips Screws Short (3). Repeat step to attach
another Back Leg (G).
3. Attach one Front Leg (F) by placing the leg over the threaded stud and
rotating it until tight. Repeat step to attach another Front Leg (F).
4. After assembling all legs, turn the product over so it rests on the legs.
5. Insert Solid Rods (E) into openings at rear of desk and fix in place by
turning clockwise to tighten.
6. Insert the Long Pipe (H) into the Solid Rod (E).
7. Insert the Long Shelf (C) onto Solid Road (E).
8. Insert the Short Pipe (D) onto the Solid Rod (E).
9. Insert the Long Shelf (C) onto the Solid Rods (E).
10. Attach the Bent Pipe (A) to Solid Rod (E) by screwing until tight.
11. To complete the installation, fix the unit to wall with the Phillips
Screws Long (1) and Plastic Anchors (2) in the predrilled holes in
Bent Pipe (A).
12. Assembly is complete.
CARE INSTRUCTIONS:
• Do not leave children unattended before product is fully assembled /
unassembled.
•
For your safety, it is recommended that two people assemble this piece.
• Dust often using a clean, soft, dry, lint-free cloth.
• Bolt all pieces immediately and wipe with a clean damp cloth.
• We do not recommend the use of chemical cleaners, abrasives, or
furniture polish on our lacquered finish.