Table of Contents
Advertisement
Introduction your new freezer
Before use
Please read these instructions carefully before using your new Matsui freezer.
The freezer is for indoor, domestic use only.
Installing
Location
When selecting a position for your Appliance you should make sure the floor is flat and firm, and the room is well
ventilated with an average room temperature of between 16 º C and º C. Locate the appliance away from direct
sunlight and source of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the appliance not
to perform properly. This unit is not designed for use in a garage or any other outside installation. Avoid locating
the appliance in moist areas. It must therefore be installed so that the Appliance has at least 10cm (.5") if free space
and the sides have cm (/4"). The Appliance door can either open to the right or the left, depending on whichever
suits you. See page 4 if you want to reverse the door swing. Do not drape your Appliance with any covering.
Moving the appliance
Position your appliance in front of its final operating position and gentle slide the appliance into position.
A minimum of two persons must be used to move the appliance.
Leveling the Freezer
Remove the packaging support form the base of the appliance and replace with the
leveling feet. Make sure the appliance is level. Use the leveling feet at the front.
If the appliance is not level, the doors and magnetic seal alignments will be affected.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate soda. Then rinse with warm water using a
damp sponge or cloth. Wash the baskets and shelves in warm soapy water and dry completely before replacing in
the freezer. The external parts of the freezer can be cleaned with wax polish. If you require more information refer to
cleaning on page 8.
Before plugging in YOU MUST
Check that you have a socket which is compatible with the plug supplied with the appliance. If not, please consult a
qualified technician for assistance.
Before switching on!
The freezer must be allowed to stand still with the door open for at least 1 hours.
DO NOT SWITCH ON UNTIL TWO HOURS AFTER MOVING THE REFRIGERATOR.
The coolant fluid needs time to settle.
Matsui MTF1708S_SE_W_WE_GB_IB_093 3
CONTROL PANEL
FREEZER BASKETS
LEVELLING FEET
ICE TRAY
GB-
05/06/09 11:27:16 AM
Advertisement
Table of Contents
