Table of Contents
Advertisement
5. Use the M3.5 screws to secure the air duct mounting bracket to the rack
6. Gently slide the air duct unit side flanges into the card guides until the unit is
7. Use the two M4 thumbscrews to secure the air duct unit to the air duct brackets.
For information about removing the air duct, see "Removing the 1U air duct option"
on page 39.
Installing a QSFP+ transceiver
The RackSwitch G8316 supports QSFP+ fiber transceivers. For the available
transceivers for the switch, see https://www-01.ibm.com/products/hardware/
configurator/americas/bhui/launchNI.wss.
The QSFP+ ports accept approved QSFP+ transceivers. The QSFP+ optical
transceiver provides an MTP cable connector for connecting to external ports.
28
IBM System Networking RackSwitch G8316, Type 8036 and Type 1611-16E: Installation Guide
chassis. Torque the screws to approximately 1.1 Nm +/- 0.1 Nm (10
inch-pounds).
seated firmly. Make sure that the foam strip is oriented on top.
Air duct mounting bracket
Card guides
Side flanges
M6 screws
M3.5 screws
Foam
M4
thumbscrews
Advertisement
Table of Contents
