Summary of Contents for Vari Lite VL3600 PROFILE IP
Page 1
Quick Start Guide REV A 06/28/22 VL3600 PROFILE IP OVERVIEW This document provides basic setup instructions INCLUDED ITEMS and safety warnings for the following product(s): VL3600 74817-001 VL3600-Touring Black VL3600 74817-101 VL3600-Touring White VL3600 74817-900 VL3600-Flight Case insert QUICK START GUIDE...
Quick Start Guide REV A 06/28/22 VL3600 PROFILE IP CURRENT VERSUS VOLTAGE TAbLE 1. CURRENT VS. VOLTAGE (1000W LED) TOTAL TOTAL provides the luminaire’s current draw at specific TABLE 1 AC VOLTAGE LUMINAIRE LUMINAIRE voltages. Total luminaire current is calculated with the...
HANGING THE FIXTURE The VL3600 PROFILE IP can be hung horizontally or 45° vertically from any structure designed to work with the type of load created by this moving luminaire. Two mounting truss hooks or other mounting hardware are required.
Page 4
Quick Start Guide REV A 06/28/22 VL3600 PROFILE IP FIGURE 1. INSTALLING bRACKETS ON LUMINAIRE ENCLOSURE Installing in Truss: Step 1. Using two people, lift luminaire into mounting position. Step 2. Secure in place with truss hook. Ensure truss hook hardware that locks hook in place (e.g.
Quick Start Guide REV A 06/28/22 VL3600 PROFILE IP FIXTURE MAINTENANCE Unscrew the screws of the luminaire head covers with a Torx screwdriver to open the luminaire head covers (no need to move the waterproof silicon ring) for after-service. Unscrew the screws of the luminaire arm covers with a Torx screwdriver to open the luminaire arm covers (no need to move the waterproof silicon ring) for after-service.
Page 6
Quick Start Guide REV A 06/28/22 VL3600 PROFILE IP Adjust the luminaire head to the illustrated state and ready for air tightness test. Remove three pressure relief valves with a 16mm hex sleeve screwdriver. After removing the three pressure relief valves, lock any two pressure relief valve holes with two M12 waterproof screws, and insert the air hose of the air tightness tester into the remaining pressure relief valve hole.
Quick Start Guide REV A 06/28/22 VL3600 PROFILE IP MENU CONTROLS The menu system is controlled by an OK (Enter), MENU (Escape), and two Arrow (▲▼) buttons. Press and hold the ENTER button, and then quickly press the UP▲, Down▼, UP▲, DOWN▼...
Page 8
Quick Start Guide REV A 06/28/22 VL3600 PROFILE IP Quick reFereNce dMX MaPS The short form DMX maps are available on the following pages. Visit the product page for full DMX maps. • table 2. 16-Bit • table 3. 16-Bit enhanced Mode (default) TAbLE 2.
Page 9
Quick Start Guide REV A 06/28/22 VL3600 PROFILE IP TAbLE 3. 16-bIT ENHANCED MODE (DEFAULT) PARAMETER PARAMETER CHANNEL CHANNEL intensity High iris intensity Low Frame 1a Pan High Frame 1B Pan Low Frame 2a tilt High Frame 2B tilt Low...
Page 10
Quick Start Guide REV A 06/28/22 VL3600 PROFILE IP It is not recommended to power any Vari-Lite fixture from a dimmer - even in 'NONDIM' mode. Dimmer WARNING: and non-dim modules are not suitable sources of power because their output modifies the AC wave form. This may work for a short time, but will eventually result in power problems, operating errors, and/or fixture failure and may void the warranty.
The information presented in this document is not intended as any commercial o er and does not form VL3600 PrOFiLe iP Quick Start Guide part of any quotation or contract, unless otherwise agreed by Signify.