Water Supply And Drain Connections - Hoshizaki DCM-230FE Service Manual

connected to the terminal which is marked with the letter L or coloured Red.
• Should the socket outlets in the installation site not be suitable for the plug supplied with
your product, the plug must be removed (cut off if it is moulded on plug) and an appropri-
ate plug fitted.
If the non-rewirable has been cut from the power supply cord, it must be disposed of.
There should be no attempt to reuse it. Inserting such a plug into a socket elsewhere
presents a serious risk of electrical shock.
• The non-rewirable plug must never be used without a fuse cover being fitted.
The correct replacement for the detachable fuse cover is identifiable from the
manufacturer's reference number stamped on the plug.
Supply of replacement fuse covers can be obtained from Hoshizaki Parts/Service Centres.
Fuses should be rated at 10A and approved to BS 1362.

5. WATER SUPPLY AND DRAIN CONNECTIONS

(For the U.K. only, the connections must be in accordance with current requirements of the Model
Water Byelaws 1986 SI No. 1147)
• Only potable water should be used for this ice dispenser.
• Water supply pressure should be minimum 0.5 bar and maximum 8 bar. If the pressure
exceeds 8 bar, use a pressure reducing valve. Do NOT throttle back the supply tap.
• A plumbing permit and services of a licensed plumber may be required in some areas.
• The ice dispenser drain is gravity flow, so ensure drainpipe has an adequate pitch or fall.
• Water should drain into an open trap.
1) By means of a suitable spanner or wrench, tighten the 1/2-3/4 Nipple (accessory) into the
Rc1/2 fitting on the rear of the ice dispenser as indicated. P.T.F.E. tape and/or a suitable
sealing compound should be used to obtain a leak free joint.
Note: Jointing compounds should be approved and suitable for potable water use.
2) Attach angled end of white flexible inlet hose (accessory) to free end of 1/2-3/4 Nipple
ensuring rubber sealing washer is correctly positioned. Hand tighten sufficiently to provide
leak free joint.
3) Attach the other end of inlet hose to the water tap, noting washer is correctly positioned
before hand tightening as above.
15