Location - Hoshizaki DCM-230FE Service Manual

Cubelet ice dispenser
Hide thumbs Also See for DCM-230FE:
Table of Contents

Advertisement

Upper Front Panel:
Top Panel:
Apron/Side Panel:

2. LOCATION

1. This ice dispenser is not intended for outdoor use. Normal operating ambi-
ent temperature should be within +5°C to +40°C. Normal operating water
temperature should be within +5°C to +35°C. Operation of the ice dispenser,
for extended periods, outside of these normal temperature ranges may affect
production capacity.
2. The ice dispenser should not be located next to ovens, grills or other high
heat producing equipment.
3. The location should provide a firm and level foundation for the equipment at
normal counter top height.
4. Allow 15 cm clearance at rear, sides and top for proper air circulation and
ease of maintenance and/or service should they be required.
5. This appliance is not suitable for installation in an area where a water jet
could be used and where dripping is not allowed.
6. Do not place anything on top of the ice dispenser or in front of the Louver.
Fig. 1
Remove the screws. Pull the bottom toward you.
Remove the Thumbscrew. Lift up the front and push away.
Remove the screws and pull toward you.
IMPORTANT
13

Advertisement

Table of Contents
loading

Table of Contents