Table of Contents
Advertisement
3. INSTALLATION
• Incorrect installation can cause harm to people, animals or things, for which the manufac-
turer cannot be held responsible.
1) Position the ice dispenser in the selected permanent site.
2) Level the ice dispenser in both the left-to-right and front-to-rear directions.
4. ELECTRICAL CONNECTION
This ice dispenser requires an earth that meets the national and local electri-
cal code requirements. To prevent possible severe electrical shock to indi-
viduals or extensive damage to equipment, install a proper earth wire to the
ice dispenser. Remove the plug from the mains socket before any mainte-
nance, repairs or cleaning is undertaken.
• This ice dispenser must have a separate power supply or receptacle of proper capacity.
See the Nameplate.
• The main control box fuses are rated at 10A, 1A and 0.5A and should only be replaced
by a qualified service engineer.
• Usually an electrical permit and services of a licensed electrician are required.
• If the supply cord and the plug should need to be replaced, it should only be done by a
qualified service engineer.
For the U.K. and the Republic of Ireland only
• The wires in the mains lead are coloured in accordance with the following code:
Green & Yellow = Earth
Blue = Neutral
Brown = Live
As the colours of the wire in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured Green-and-Yellow must be connected to the terminal in the
plug which is marked with the letter E or by the symbol
and-Yellow. The wire which is coloured Blue must be connected to the terminal which is
marked with the letter "N" or coloured Black. The wire which is coloured Brown must be
WARNING
THIS APPLIANCE MUST BE EARTHED
or coloured Green or Green-
14
Advertisement
Table of Contents
