Tig Welding; General; Connecting The Gas Cylinder; Preparation - Fronius AccuPocket 150/400 TIG Operating Instructions Manual

TIG welding

General

NOTE!
Do not use pure tungsten electrodes (colour-coded green) if the TIG welding
process has been selected.
Connecting the
gas cylinder
Danger from falling gas cylinders.
This can result in severe personal injury and damage to property.
▶
▶
1

Preparation

1
2
3
4
5
44
WARNING!
Place gas cylinders on a solid, level surface so that they remain stable. Se-
cure gas cylinders to prevent them from falling over.
Observe the safety rules of the gas cylinder manufacturer.
Press the On/Off button for at least two seconds to turn off the power
source
- the indicators go out
Plug the TIG welding torch into the (-) current socket and turn it clockwise to
latch it in place
Plug the TIG Multi Connector plug of the TIG welding torch into the TMC
connection of the power source
Set up the welding torch in accordance with the welding torch Operating In-
structions
Plug the grounding cable into the (+) current socket and turn it clockwise to
latch it in place
2
max. 5 bar
(72 psi)