Safety Remarks - Leica Q2 Instruction Manual

Table of Contents

Advertisement

SAFETY REMARKS

GENERAL INFORMATION
• Do not use your camera in the immediate vicinity of devices that
generate powerful magnetic, electrostatic or electromagnetic
fields (e.g. induction ovens, microwave ovens, television sets or
computer screens, video game consoles, cell phones, broadcast-
ing equipment). Their electromagnetic fields can interfere with
image recordings.
• Strong magnetic fields, e.g. from speakers or large electric motors
can damage the stored data or disrupt shooting.
• Switch off the camera, remove the battery briefly, replace it and
switch the camera back on in case of a camera malfunction due
to the effects of electromagnetic fields.
• Do not use the camera in the immediate vicinity of radio transmit-
ters or high-voltage power lines. Their electromagnetic fields may
also interfere with image recordings.
• Always store small parts e.g. the accessory shoe cover as follows:
– out of the reach of children
– in a safe location, where they will not get lost or stolen
• State-of-the-art electronic components are sensitive to static dis-
charge. You can easily pick up charges of several 10,000 volts by
simply walking on synthetic floor coverings. A static discharge can
occur when you touch the camera and especially if it is placed on
a conductive surface. A static discharge on the camera housing
poses no risk for the electronics. Despite built-in safety circuits,
you should avoid direct contact with external camera contacts like
those in the flash shoe.
• Take care not to soil or scratch the sensor for lens detection in the
bayonet. You must similarly prevent direct contact of the bayonet
with grains of sand or similar particles, as these could cause irrep-
8
SAFETY REMARKS
arable damage. This component must only be cleaned with a dry
cloth (in system cameras).
• Use a cotton or linen cloth instead of a microfiber cloth from an
optician's (synthetic) when cleaning the contacts. Make sure to
discharge any electrostatic charge by deliberately touching a
heating or water pipe (conductive, grounded material). Dirt depos-
its and oxidation on the contacts can be avoided by storing your
camera in a dry location with the lens cap and the flash shoe/
viewfinder cap (in system cameras) attached.
• Only use accessories specified for this model to prevent faults,
short circuits or electric shock.
• Do not attempt to remove parts of the housing (covers) yourself.
Repairs must be done at authorized service centers only.
• Protect the camera against contact with insect sprays and other
aggressive chemicals. Petroleum spirit, thinner and alcohol must
not be used for cleaning. Some chemicals and liquids can damage
the camera housing or the surface finish.
• Rubber and plastics are known to expel aggressive chemicals
and should therefore not be kept in contact with the camera for
extended periods of time.
• Prevent any sand or dust or water penetration into the camera,
e.g. during snowfall or rain or on the beach. Be extra careful when
changing the lens (in system cameras) and when inserting or
removing the memory card and rechargeable battery. Sand and
dust can damage the camera, the lens, the memory card and the
battery. Moisture can cause malfunctions and irreparable damage
to the camera and memory card.
LENS
• A camera lens can have the effect of a magnifying glass when
exposed to direct frontal sunlight. The camera must therefore be
protected against extended exposure to direct sunlight.

Advertisement

Table of Contents
loading

Table of Contents