Leica Q2 Instruction Manual page 211

Camera does not focus
AF metering field is framed in red with
activated AF; images out of focus
No AF metering field selectable
AF assist lamp does not light up
Video recording
No video is recorded
Video shooting stops
Review and photo management
Selected images cannot be deleted
File numbering does not start at 1
The time and date settings are incorrect or are
not displayed
The time and date stamp on images are
incorrect
The time and date stamp on images are
unwanted
Pictures/recordings are damaged or missing
Desired object part is too close to the camera
Desired object part is very far away
Object not suitable for AF
Focusing was unsuccessful
Focus ring not in AF position
Automatic Metering Field Control or Face Detection in AF
Mode is selected
One of the scene modes is currently active
Image Review is activated
Camera is in Standby mode
Camera is in video shooting mode
Function is deactivated
The camera is overheated and the function was
temporarily disabled to protect the camera
Maximum length of individual video sequence was reached
The memory card's write speed is too low for the selected
video resolution/compression
Some of the selected images are write protected
The memory card contains previously stored images
The camera has not been in use for an extended period of
time (the battery was removed)
Time settings are incorrect
Setting was ignored
The memory card was removed while the readiness
indicator was flashing
The memory card formatting is faulty or the card is
damaged
Select Macro mode
Exit Macro mode
Use Focus lock or select manual focus
Try to focus again
Turn the focus ring to the AF position
Select other control mode
Select the setting under
P-A-S-M Scene Mode
Deactivate Image Review
Press the shutter button to the first pressure point
Change the mode
Activate AF
Allow camera to cool down
Insert another memory card or change the storage method
Remove write protection (using the device with which the
file was originally set to write protected)
See section "Data Management"
Insert a charged battery and configure the correct settings
Set the time correctly
Caution: Time settings will be lost if the camera is not
used/remains in storage with a depleted battery over an
extended period of time
Cannot be removed in retrospect
Deactivate the function as needed
Never remove the memory card while the readiness
indicator is flashing. Charge the battery.
Reformat the memory card
(Caution: Loss of data!)
211
FAQ