Excell KWH3 User Manual page 11

EXCELL PRECISION CO., LTD.
Preset "Beeper value" ( Refer to NOTE )
Press
Press
Press
Press
Press

Preset Single point (preset low limit only):
After "preset low limit" procedures is completed and the display shows
, then press
"preset single point" procedure is completed.
NOTE
_
A Setting for the status that LCD is on and the beeper beep:
0 = When stable, the beeper beeps and LCD is on.
1 = When stable, the beeper beeps; whether stable or not, LCD is on.
2 = Whether stable or not, the beeper beeps and LCD is on.
3 = Activates alarm mode. When the weight is over High Limit and stable, the
LCD indicator is on, and RelayCard is activated.
B Setting for the beep status:
0 = No beep
1 = OK (when the weight is over Low Limit & under or equal to High Limit.),
the beeper beeps.
2 = When the weight is under or equal to Low Limit & over High Limit, the
beeper beeps.

Under Status in Preset Low Limit (preset single point only)
The BEEP, LCD mode should be fixed as follows:
02029018
key 1 time the display shows
key 2 times the display shows
key 1 time the display shows
key 2 times the display shows
key 1 times the display shows
key again, the display shows
x x
_ _
A B
When over "Low Limit", the beeper beeps and
Whether stable or not, the beeper beeps and LCD indication is on
e.g. Beeper value = 22
.
9
 
 
 
 
.

.
. This means that the
is off
ZSME300000363