Input/Output Signals; Figure 4-5 User I/O Connector Pinouts - Novanta v40 User Manual

INPUT/OUTPUT SIGNALS

Input/output signals
V40's input/output signals are divided into three categories: auxiliary DC power, input signals, and
output signals. Signals in each category are fully described in the section below. Figure below illustrates
the pin arrangement of the User I/O (15-pin female D-type subminiature) connector on v40 's rear panel.
Important Note: See DB-9 connections later in this section for signal descriptions and pinouts of
the SAB model's side-mounted DB-9 connector.
Turn off DC power before installing or removing any plug or cable from the User I/O connector.
Ensure that user connections are made to the appropriate pins and that the appropriate signal levels
are applied. Failure to do so may damage the laser.
Caution: Possible Equipment Damage

Figure 4-5 User I/O connector pinouts

PAGE | 57