Fastening From Above; Fastening From Below; Figure 1-2 Fastening From Above; Figure 1-3 Fastening From Below - Novanta v40 User Manual

FASTENING FROM ABOVE

Fastening from above
To fasten to a mounting surface from above, perform the following steps:
1. Refer to the appropriate outline and mounting drawing for dimensions and then drill and tap
three 1/4–20 UNC holes into your mounting surface. These hole locations should correspond to
the two slots labeled "A" and the thru hole labeled "B" shown in Figure 1-2.
2. Place on the mounting surface so that slots "A" and hole "B" on the base plate line up with the
3. Insert 1/4–20 × 5/8" UNC capscrews through 's base plate into the threaded holes of the
tapped holes in the mounting surface.
mounting surface. Turn the screws by hand until the threads engage.
4. Tighten all three capscrews to a torque of 6 ft lbf (8 N m) maximum.

Fastening from below

To fasten to a mounting surface from below, perform the following steps:
1. Refer to the appropriate outline and mounting drawing for dimensions and then drill three 0.261"
(6.6 mm) diameter holes into your mounting surface. Hole locations should correspond to the
threaded holes labeled "C" shown in Figure 1-3.

Figure 1-2 Fastening from above

Figure 1-3 Fastening from below

PAGE | 16