Led Explanation; Port And Button Description - TP-Link RE200 User Manual

Chapter 1
1 2 1
You can check the extender's working status by following the LED Explanation table.
1 2 2
Ports or Buttons
(WPS Button)
RESET (Hole)
Ethernet Port
Downloaded from ManualsNet.com

LED Explanation

Name Status
5GHz On/Off
2.4GHz On/Off
Solid green
Solid red
(Signal)
Off
On/Off
(Ethernet)
On/Off
(Power)
Blinking
On
Blinking
(WPS)
Off

Port and Button Description

Press the WPS button on your host router, and immediately press
the extender for 1 second. The
to solid on, indicating successful WPS connection.
Use a pin to press the button for 1 second to reset the extender.
Connect your device to the Ethernet port of the extender via an
Ethernet cable to join the Wi-Fi network.
search engine
Get to Know About Your Extender
Indication
The extender is connected or not connected to the 5GHz
wireless network of your host router.
The extender is connected or not connected to the
2.4GHz wireless network of your host router.
The extender is connected to your router's wireless
network and is in a suitable location.
The extender is experiencing poor signal strength. Try
relocating it closer to your host router.
No wireless connection is established.
The Ethernet port is connected or not connected to a
powered-on device.
The extender is on or off.
The system is starting up or firmware is being upgraded.
WPS connection is established.
WPS connection is in progress.
WPS connection has been established for more than 5
minutes or WPS connection failed.
Description
LED of the extender should change
on
4