Table of Contents
Advertisement
Chapter 1
1. 2. 1.
LED Explanation
You can check the extender's working status by following the LED Explanation table.
Name
(RE)
2.4GHz
5GHz
POWER
1. 2. 2.
Port and Button Description
Ports or Buttons
(RE Button)
LED Button
ON/OFF Button
Reset Button (Hole)
Ethernet Port
Status
Solid Blue
The extender is connected to the router, and is in a good location.
The extender is connected to the router, but is too far away from the
Solid Red
router.
The extender is trying to connect to the network via WPS. This
Blinking
process may take up to 2 minutes.
Off
No active connection.
The extender is connected to the 2.4GHz wireless network of your
On
host network
Off
No 2.4GHz wireless connection.
The extender is connected to the 5GHz wireless network of your host
On
network
Off
No 5GHz wireless connection.
On
The extender is on.
Blinking
The extender is initializing.
Off
The extender is off.
Press the WPS button on your host router, and immediately press the RE button on
the extender. The RE LED of the extender should change from blinking to solid on,
indicating successful WPS connection.
To turn all LEDs on or off, press the LED button.
To turn on or off the extender, press the ON/OFF button.
Press and hold the Reset button until all the LEDs turn on momentarily to reset the
extender to its factory default settings.
Connect your Ethernet-only device to the Ethernet port of the extender to join the
Wi-Fi network.
Get to Know About Your Extender
Indication
Description
4
Advertisement
Table of Contents
