TP-Link RE200 User Manual page 48

FAQ
Q1 How to reset the extender to its factory default settings?
• With the extender powered on, use a pin to press the
extender will reboot.
• Log in to the extender's web management page. Go to
Backup & Restore
Q2 What should I do if I forget my login password?
• If you are using a TP-Link ID to log in, or you have enabled the Password Recovery
feature of the extender, click
instructions to reset it.
• Refer to FAQ > Q1 to reset the extender, and then visit
create a new login password.
Note:
The extender must be reconfigured after a reset to access the internet. Please note down your login password for future
logins.
Q3 What should I do if I forget my wireless password?
• In Range Extender mode, the extender shares the same wireless passwords as those
of your host networks. You can go to
check the password of your host networks.
• In Access Point mode, please connect your computer to the extender using an
Ethernet cable and follow the steps below:
1. Visit http://tplinkrepeater.net, and log in with the password you set for the extender.
2. Go to
password.
Q4 What should I do if I can't access the web management page?
This can happen for a variety of reasons. Please try the methods below to log in again.
• If your computer is wirelessly connected, make sure that you have connected to the
extender's SSID.
• If your computer is connected via an Ethernet cable, please make sure that the
connection is stable.
• Make sure your computer is set to obtain an IP address and DNS server address
automatically.
• Verify that
Enter.
Downloaded from ManualsNet.com
and click Factory
Forgot Password?
Settings > Wireless >
http://tplinkrepeater.net
search engine
RESET
Restore.
on the login page and then follow the
Settings > Wireless
Wireless Settings to retrieve or reset your wireless
is correctly entered in the web browser and press
button for 1 second. The
Settings > System Tools
http://tplinkrepeater.net
> Connect to Network
>
to
to
45