Advertisement
5
Power Up
Current Mode
Ready to Scan
6
Press and immediately release the power inserter button to start a scan.
When scan is complete and satellites are found, the LED will turn steady blue.
Watch TV. Enjoy!
PLEASE BE PATIENT! Antenna unit may lock onto satellite in as little as 2 minutes, but may occasionally take up to 10-15 minutes.
If you wish to start a new scan (e.g., the unit gets moved and you lose reception): press and release the power inserter button.
The power inserter has a built-in alarm that sounds when the coax is disconnected from the antenna or the power inserter.
Access additional product and warranty information in the on-line owner's manual at kingconnect.com/support.
If the antenna does not start scanning when you press the
button:
If antenna scans but you get no TV picture:
If picture goes in and out:
QUESTIONS? (952) 345-8147
All trademarks are the sole property of their respective owners. PN 21962 Rev F © 2022 KING
OR OR
OR OR OR OR
BL
OFF
BLUE
OFF
BL
OFF
BL
OFF
BLUE
TROUBLESHOOTING
Double check all connections and make sure power inserter is plugged into
a known good power source.
Make sure TV's source input is from the receiver.
Check for line of sight obstructions. Move antenna to have better view of
southern sky and scan again.
of the signal, like moving tree branches.
OR
Pulsates orange for about 10 seconds.
To enable alarm, see the on-line owners' manual.
BLUE
OFF
OR
BLUE
BL
OFF
BL
BLUE
Repeats...
Steady blue
Repeats...
Advertisement
