Operation; Light Guide Connection; Power Connection - SCHOTT KL 2500 LED User Manual

16

2. Operation

EN

2.1 Light guide connection

2.2 Power connection

First, open the locking screw of the light guide holder by turning it counter-
clockwise. Then push the light guide in as far as it will go and tighten the locking
screw again by turning it clockwise.
When inserting light guides with a guide pin, make sure that it aligns in one of
the two guide slots.
Insert the hollow plug of the enclosed power supply unit into the socket on
the light source.
Ensure that the KL 2500 LED cold light source is operated only in the specified
voltage range and with the enclosed power supply unit.
Plug the three-pole power cable of type H05VV-F3G0.75 (available as an
accessory) into the connection socket of the enclosed power supply unit
provided for this purpose. When replacing the power cord, use only power
cords of the same type.