Operation; Non-Humidified Models - Hatco Glo-Ray GRCD-1P Installation & Operating Manual

OPERATION

!
CAUTION
Some exterior surfaces on the unit will get hot. Use
caution when touching these areas to avoid injury.
!
WARNING
To prevent any injury or damage to the unit do not
pull unit by power cord.
!
WARNING
To prevent any injury, discontinue use if power cord
is frayed or worn.
!
WARNING
To prevent any injury, do not place food directly
on glass or stainless steel surfaces. Food product
must be wrapped or boxed.
!
CAUTION
To avoid any injury on GRCD-PDG and
GRCDH-PDG series units do not come in contact
with the heated glass shelf while unit is in operation.
!
WARNING
To avoid any injury, on GRCD-PDG and
GRCDH-PDG series units do not allow liquids
to spill onto the heated glass shelf.
CAUTION
Do not allow the glass shelf to overheat
on GRCD-PDG and GRCDH-PDG series units.
Overheating may cause the food containers
to melt or soften.
CAUTION
Do not use food pans, ceramic dishes, or abrasive
materials on heated glass shelves. Food pans,
ceramic dishes, and abrasive materials may scratch
the glass shelf marring its appearance
and making it susceptible to dirt accumulation.
It is recommended that glass shelves be used
for food products contained in disposable paper
or plastic containers or wrapping.
NOTE: Scratches on heated glass shelves are not
covered under warranty.
Form No. GRCD/HDM-0703
Top & Center Heat Indicators*
ON
OFF
Power Switch
Top Heat Control
*Dual tier models only.
Figure 11. Control Panel – Non-Humidified Models

NON-HUMIDIFIED MODELS

1. Plug cabinet into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. See Specifications for details.
2. Turn the Power Switch to the ON position. See
Figure 11.
3. On start-up set all heat controls at maximum
to assure safe food holding.
On dual tier models, the Top and Center Heat
Indicators will light when controls are
in the ON position.
NOTE: Temperature settings may vary depending upon
product make-up and consistency.
4. Allow unit 30 minutes to reach operating
temperature.
14
Center Heat Control*
HATCO GLO-RAY
Base Heat Control