Accessories - Hatco Glo-Ray GRCD-1P Installation & Operating Manual

ACCESSORIES

SLANT LEG KIT (GRHD Models Only
without Humidity)
The Slant Leg Kit tilts the unit in a forward position
for optimum display of food product.
1. Remove the pan rail or sandwich chutes.
2. Carefully lay unit on its side (requires two people).
CAUTION
Do not lay unit on the side with the control panel
or the front of a curved glass unit, damage to unit
could occur.
3. Remove screws from bottom right side and bottom
left side of unit. See Figure 13.
4. Position slant leg over holes with long leg towards
the rear, and install using original screws.
5. Feet have an adjustable range of 3/4" to 1-1/2"
(3 - 6 mm). Return unit to upright position
and adjust feet to desired height.
SANDWICH CHUTES
(GRHD Models Only)
Sandwich Chutes provide for upright display
of sandwich products.
NOTE: The following assembly procedure is the same
for both single and double tier units.
1. Remove protective film from all parts.
2. Remove the side glass panels by pushing
in the spring loaded pins and removing panels.
3. Install the end pieces to the unit using knurled
thumbscrews. Tighten securely but do not
overtighten. See Figure 14.
4. Re-install side glass panels.
5. Install separator and sandwich chutes.
DISPLAY SIGN HOLDER
(GRHD Models Only)
The display sign holder allows you to customize your
unit with product name and/or graphics.
1. Remove screws from upper left and right side of unit
as shown in Figure 15.
2. Install sign holder using original screws.
3. Insert sign (not included) and plexiglas cover.
Form No. GRCD/HDM-0703
Figure 13. Slant Leg Kit - GRHD Models without Humidity
End Piece
Figure 14. Sandwich Chutes - GRHD Models Only
Figure 15. Display Sign Holder - GRHD Models Only
18
Knurled Thumbscrew