Location; Operation - Hatco FLAV-R-SAVOR LFST-48 Installation And Operating Manual

INSTALLATION (CONTINUED)
9. Install door handles to top of doors on front and
back of cabinet, using the screws supplied.
(See Figure 8.)
Figure 8. Door Handle Installation

OPERATION

WARNING
Some exterior surfaces on the unit will get hot.
Use caution when touching these areas to avoid
injury.
WARNING
To prevent any injury, discontinue use if power
cord is frayed or worn.
CAUTION
Unit is not weatherproof. For safe and proper
operation the unit must be located indoors
where the ambient air temperature is a minimum
of 70°F (21°C) and a maximum of 85°F (29°C).
1. Plug unit into an electrical outlet of the correct
voltage, size and plug configuration. See
SPECIFICATIONS for details.
2. Turn the Power Switch on the control panel to the
ON position. (See Figure 9).
3. To set the temperature, turn the red Mode Switch
counterclockwise to the SP-1 position indicated
on the controller.
4. Adjust the Setpoint Screw to the desired
temperature.
Form No. LFSTM-0807

LOCATION

For safe and proper operation, the unit must be
located a minimum of 1" (25 mm) from
combustible walls and materials. If safe distances
are not maintained, discoloration or combustion
could occur.
To avoid any injury or damage, locate the Large
Capacity Holding Cabinet at the proper counter
height, in an area that is convenient for use. The
location should be level to prevent the unit or its
contents from accidentally falling, and strong
enough to support the weight of the unit and food.
NOTE: The unit must be transported in the upright
position.
5. Turn the red Mode Switch to the TEMP position.
The cabinet temperature range is room
temperature to 180°F.
6. Allow 20 to 30 minutes for unit to reach operating
temperature.
SP1
TEMP.
Setpoint
Power
Switch
Figure 9. Control Panel
6
WARNING
CAUTION
Mode Switch
F
Screw