Grhd Models - Hatco Glo-Ray GRCD-1P Installation & Operating Manual

INSTALLATION

GRHD MODELS

1. Remove plastic bag containing 4 adjustable legs
from inside the unit.
2. Remove all components from inside the unit. See
Figure 10.
3. Remove all doors by grasping the door edges then
lifting up and out of the bottom channel. See
Figure 10. Discard the protective cardboard from
top of each door.
NOTE: Do not remove the plastic glides from top
of door glass. See Figure 10.
4. Carefully lay unit on its side (requires 2 people).
Install legs to bottom of unit as shown in Figure 8.
Hand tighten legs until snug. Do not overtighten.
Return unit to the upright position.
NOTE: If your unit is equipped with optional Slant Leg
Kit, see Accessories for installation instructions.
CAUTION
Do not lay unit on the side with the control panel
or the front of a curved glass unit, damage to unit
could occur.
NOTE: Legs are adjustable for leveling the unit. Use
a 9/16" (14 mm) open-end wrench to make leveling
adjustments once the unit is placed in final position.
5. Remove tape and protective film from all surfaces
of unit.
6. Install pan rail (GRHD units) or pan skirt, divider
and water trough (GRHDH units).
7. Re-install rear doors.
NOTE: If your unit is equipped with optional Sandwich
Chutes and/or Display Sign Holder, see Accessories
for installation instructions.
Form No. GRCD/HDM-0703
Rear Doors
Pan Divider
(GRHDH models)
Side Glass
Pan Rail (GRHD models)
Figure 10. Exploded View - GRHD Models
12
Door Glides
(2 ea. door)
Water Trough
(GRHDH models)
Pan Skirt
(GRHDH models)