Display Light Bulb Replacement - Hatco Glo-Ray GRCD-1P Installation & Operating Manual

DISPLAY LIGHT BULB REPLACEMENT

The display lights are incandescent light bulbs which
illuminate the warming area. These bulbs have a special
coating to guard against injury and food contamination
in the event of breakage.
1. To replace a light bulb, disconnect the power supply
and wait until the unit has cooled.
2. Bulbs have a threaded base. Unscrew the light bulb
from the unit and replace it with a new specially
coated incandescent bulb.
NOTE: Hatco shatter-resistant light bulbs meet N.S.F.
standards for food holding and display areas. For 120,
120/208 and 120/240 Volt applications, use Hatco part
#02.30.043.00. For 220 or 240 Volt applications, use
Hatco part # 02.30.058.00.
!
WARNING
Only light bulbs which meet or exceed N.S.F.
standards, specifically designed for food holding
areas must be used. Breakage of light bulbs not
specifically coated could result in personal injury
and/or food contamination.
GROUND FAULT CIRCUIT INTERRUPT
The GRCD-PDG series is supplied with a built
in Ground Fault Circuit Interrupt (GFCI) which
is designed to turn electrical power off to the internal
components when there is a short circuit
or electrical fault.
To reset the "GFCI" push the red reset button in.
If the "GFCI" continues to trip, contact your local
Authorized Hatco Service Agency.
!
If service is required on this unit, contact
your Authorized Hatco Service Agent, or contact
the Hatco Service Department at 800-558-0607
or 414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
!
This product has no "user" serviceable parts.
To avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents
and Genuine Hatco Parts when service is required.
!
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which they
are used. Some aftermarket or generic replacement
parts do not have the characteristics that will allow
them to operate safely in Hatco equipment.
It is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure
to use Hatco Replacement Parts may subject
operators of the equipment to hazardous electrical
voltage, resulting in electrical shock or burn.
17
MAINTENANCE
WARNING
WARNING
WARNING
Form No. GRCD/HDM-0703