Huawei V100R002C01 User Manual page 40

Tecal es3000 high performance pcie ssd card
Table of Contents

Advertisement

Tecal ES3000 High Performance PCIe SSD Card
User Guide
Preparations
Before installing the ES3000 driver, check that:
l
l
Procedure
Step 1 Log in to the operating system (OS) as an administrator.
Step 2 Navigate to the directory storing the driver package, for example, /root/ES3000.
Step 3 Install the ES3000 driver by running the following command:
rpm -ivh hio-2.0.0.5-2.6.32.12_0.7_default.x86_64.rpm
After successful installation, the command output is as follows:
Preparing... ########################################### [100%]
Issue 04 (2014-03-05)
NOTE
l If you install multiple ES3000s on a server, you need to install the driver only once.
l A driver package is named "hio-<driver version>-<supported kernel version>.<hardware
platform>.rpm", for example, hio-2.0.0.5-2.6.32.12_0.7_default.x86_64.rpm.
l The driver package must support the kernel version. You can run the uname -r command to obtain the
kernel version.
uname -r
The following command output is an example:
2.6.32.12-0.7-default
After the hyphens (-) in the command output are replaced with underscores (_), the command output
must be the same as the kernel version in the driver package name.
l Run the hio_info command and check the command output. If the value of Driver version is not blank
in the command output, the driver of an earlier version has been installed. You need to uninstall the
driver of the earlier version. For details about how to uninstall the driver, see
ES3000 Driver in
Linux.
[root@localhost ~]# hio_info
hioa
Size(GB):
Max size(GB):
Serial number:
Driver version:
Bridge firmware version:
Controller firmware version:
Battery firmware version:
Battery
status:
Run time (sec.):
Total
IO
read:
Total
IO write:
Total
read(MB):
Total write(MB):
IO timeout:
R/W error:
Max bit flip:
Average EC:
Max bad block rate:
Event log:
Health:
You have properly installed the ES3000 in the server.
You have uploaded the driver package to the server by using WinSCP or other software,
for example, the /root/ES3000 path.
1:hio
########################################### [100%]
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
803
803
030PXS10CB000062
2.0.0.40
326
NA
111
OK
858781
4010544002
2609916620
53282383
37119436
0
0
28
149
0.089%
OK
OK
3 Installation and Configuration
5.3.1 Upgrading the
32

Advertisement

Table of Contents
loading

Table of Contents