Table of Contents
Advertisement
Available languages
Available languages
V1.0
INTRODUCTION
Convert an angle grinder into a metal-cutting chop saw. Cut pipe, rebar or
tubing at 0 to 45° angles.
SAFETY
WARNING! Read and understand all instructions before using this tool.
The operator must follow basic precautions to reduce the risk of
personal injury and/or damage to the equipment.
Keep this manual for safety warnings, precautions, operating or inspection
and maintenance instructions.
WORK AREA
1.
Operate in a safe work environment. Keep your work area clean, well-lit
and free of distractions. Place lights so you are not working in a shadow.
2.
Keep anyone not wearing the appropriate safety equipment away from
the work area.
3.
Store unused tools properly in a safe and dry location to prevent rust
or damage. Lock tools away and keep out of the reach of children.
4.
Do not install or use in the presence of flammable gases, dust or liquids.
PERSONAL SAFETY
WARNING! Wear personal protective equipment approved by the
Canadian Standards Association (CSA) or American National Standards
Institute (ANSI).
PERSONAL PROTECTIVE EQUIPMENT
1.
Always wear impact safety goggles that provide front and side protection
for the eyes. Eye protection equipment should comply with CSA Z94.3-07
or ANSI Z87.1 standards based on the type of work performed.
2.
Wear the appropriate type of full-face shield in addition to safety
googles, as the work can create chips, abrasive or particulate matter.
3.
Wear gloves that provide protection based on the work materials or to
reduce the effects of tool vibration.
a.
Do not wear gloves when operating a tool that can snag the
material and pull the hand into the tool.
4.
Wear protective clothing designed for the work environment and tool.
Visit www.princessauto.com for more information
Heavy Duty Angle Grinder Stand
9004409
3
Advertisement
Table of Contents
