PRESONUS Quantum 4848 Owner's Manual page 51

6
Studio One Profesional Quick Start
6.5 Monitor Mixing in Studio One
6.5.2 Punching In
The Quantum 4848's unique integration with Studio One and ultra-low latency
performance make punching in easier than ever. This section will guide you
through setting up a punch in so that there is no change sonically between
audio you're playing back and the audio you're recording.
Quantum 4848与Studio One的独特集成和超低延迟性能，使punching in比
以往更容易。本节将指导你如何设置 punching in，使你正在播放的音频
和正在录制的音频之间没有声音上的变化。
1. Before you begin, go to Studio One>Preferences and click on the Advanced tab.
在你开始之前，进入 Studio One>Preferences 并点击 Advanced（高级）标签。
2. On the Console preference tab, check the box next to "Audio track monitoring mutes
playback (Tape Style). This will allow you use Cue Mix to monitor during a punch in.
Click Apply and then OK.
在控制台优先选项卡上，勾选 "Audio track monitoring mutes playback（磁带风格）" 旁
边的方框。这可以使你在 punch in过程中，使用Cue Mix来监听。点击 "Apply"，然
后"OK" 确定。
3. After you have recorded your audio, set the punch in and out points in the timeline.
录制完音频后，在时间轴上设置 "punch in & out"。
4. Enable the Autopunch button the left of the Metronome settings in the transport.
启用传输工具中节拍器设置左侧的 " Autopunch"按钮。
Quantum 4848
Owner'sManual
49