Table of Contents
Advertisement
installation
Inner Glass Panel Installation / Removal
Inner Glass Panel (Firebox Glass) Installation / Removal
Note: glass panels must be installed to operate fireplace
Note: glass panels must be installed to operate fireplace
WARNING: GLASS HANDLING
WARNING: GLASS HANDLING
We recommend using the glass vacuum holders supplied by the manufac
turer. Lower the glass to rest in a safe place, this is to prevent damage to the
We recommend using the glass vacuum holders supplied by the
glass edges. Extra care must be taken when removing/installing the glass.
manufacturer. Lower the glass to rest in a safe place to prevent
Breakage or damage to the edge of the glass which occurs as a result of
damage to the glass edges. Extra care must be taken when remov-
careless handling will not be covered under warranty.
ing/installing the glass; breakage or damage to the edge of the
glass which occurs as a result of careless handling is not covered
• We recommend handling the glass with supplied vacuum clamps
under warranty.
• When removing glass–prepare a soft, scratch resistant
surface to place the 60-3/8"x 18-1/4" glass
• We recommend handling the glass with supplied vacuum clamps
• Never clean or remove hot glass
• When removing glass, prepare a soft, scratch resistant
surface to place the 60-1/4"x 19-13/16" glass
Note: The suction cups may leave a round film on the glass when
• Never clean or remove hot glass
used. Ensure that the glass is cleaned using a fireplace glass
cleaner after each removal and prior to operating the appliance.
Note: The suction cups may leave a round film on the glass when
used. Ensure that the glass is cleaned using a fireplace glass cleaner
after each removal and prior to operating the appliance.
1. Remove outer safety barrier glass panels if previously installed–see instruc
tions in this manual.
1. Remove outer safety barrier glass panels if previously installed–see instruc-
tions in this manual.
2. Remove outer panels installed in unit - see panel removal section in this manual.
2. Remove outer panels installed in unit - see panel removal section in this manual.
Press glass vacuum clamps in open position firmly onto surface of glass.
Bring handles together to close.
Press glass vacuum clamps in open position firmly onto surface of glass.
Bring handles together to close.
Open
Open
Handle glass with supplied vacuum clamps
Note--the following installation diagrams do not include the vacuum
Handle glass with supplied vacuum clamps
clamps but it is strongly recommended to use clamps at
all times when handling the firebox glass.
Note--the following installation diagrams do not include the
vacuum clamps but it is strongly recommended to use
clamps at all times when handling the firebox glass.
70 | City Series CV60E-1
70 ............................................. |City Series CV60E-1
Closed
Closed
Glass removal video
Glass removal video
3. From the front inside lower panel of the unit--pivot the glass support into
3. From the front inside lower panel of the unit--pivot the 3 glass supports
upright position as shown below.
into upright position as shown below.
-
-
Glass supports in upright position
Glass supports in upright position
4. Open the 8 clamps at the top of the glass.
4. Open the 8 clamps at the top of the glass.
With the top clamps in open position, use your hands to pull the two glass
gasket rails towards you.
With the top clamps in open position, use your hands to pull the two glass
gasket rails towards you.
Clamps in closed position
Clamps in closed position
owner's information
Clamps in open position, rail pulled
forward
City Series CBV0E
Clamps in open position, rail pulled
forward
| 19
Advertisement
Table of Contents
