Starting / Stopping The Engine - Stihl RL-MM Instruction Manual

English
Mounting the MultiTool
: Arrange the blades in the order they
will be fitted on the shaft, noting the
following points:
Left-hand and right-hand blades are
different. The direction of rotation is
marked with arrows on the gearbox
and blades. Make sure the arrows
point in the same direction.
6
5 4
: Rotate the inner right-hand blade (4)
on the shaft until it can be pushed
into position – check the direction of
rotation again (arrows).
The hub of the inner blade is larger
than that of the outer blade.
: Rotate the outer, right-hand blade
(5) on the shaft until it can be
pushed into position – check the
direction of rotation again (arrows).
12
: Insert and engage hitch pin (6) in
the hole in the shaft – fold the hitch
pin flat against the blade.
: Use the same procedure to mount
the blades on the left-hand side.
Starting / Stopping the
Engine
Starting
: Secure the handlebar in the
operating position.
: Retract the wheels, if fitted – see
notes on "Wheels" in the
MultiEngine instruction manual.
: Place the unit on a patch of clear
ground. It must rest securely on the
engine flange and the support on
the frame. Check that the working
tools are not touching the ground or
any other obstacles.
Make sure you have good balance
and secure footing – as shown in
the illustration. To reduce the risk of
injury from contact with rotating
attachments, always stand to the
side of the power tool, never in front
of or near the attachments.
RL-MM