Mounting The Multitool - Stihl RL-MM Instruction Manual

Mounting the MultiTool

Removing existing MultiTools
: Wear gloves to reduce the risk of
injury from contact with sharp,
pointed MultiTools and/or the hot
surface of the gearbox.
: Remove the hitch pin and pull the
MultiTool (if fitted) off the shaft.
: Clean the gearbox if necessary.
Also refer to chapter on "Mounting the
MultiTool" in the instruction manual of
the other MultiTool.
RL-MM
Checking position of gearbox
1
3
To reduce risk of injury from MultiTool
rotating in the wrong direction, check
that position of gearbox is correct and
adjust if necessary.
The gearbox output shaft (1) must be
below the drive tube (2) so that the
MultiTool rotates in the direction of the
arrow (3).
Adjusting position of gearbox
2
: Loosen clamp screws on gearbox.
: Turn gearbox 180°.
: Line up the gearbox in the correct
position.
: Tighten down the two clamp screws
on the gearbox in the following
sequence:
– Tighten first screw moderately.
– Tighten second screw moderately.
– Tighten down first screw firmly.
– Tighten down second screw firmly.
English
11