Mounting The Kombitool; Mounting The Cutting Blade - Stihl FCB-KM Instruction Manual

English

Mounting the KombiTool

2
1
Push the lug (1) on the drive tube
N
into the slot (2) in the coupling
sleeve as far as stop.
3
4
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
Tighten down the star knob (4)
N
firmly.
Removing the KombiTool
Reverse the above sequence to
N
remove the drive tube.
10

Mounting the Cutting Blade

1
Lay the power edger on its back so
N
that the blade mounting (1) faces
up.
5
6
4
2
3
Insert the stop pin (2) or screwdriver
N
– see "Special Accessories" – into
the hole (3) as far as stop – apply
slight pressure and turn back and
forth together with the thrust
washer (4) until the pin slips into
position and blocks the shaft.
Fit the combination wrench (5) on
N
the nut (6).
Loosen and unscrew the nut
N
clockwise (left-hand thread).
Remove the thrust washer.
N
7
6
4
9
8
Place the blade (7) on the thrust
N
plate (8).
WARNING
Collar (see arrow) must engage the
blade's mounting hole.
Fit the thrust washer (4) on the
N
shaft (9) and block the shaft.
Screw the mounting nut (6) on to the
N
shaft counterclockwise and tighten
it down firmly.
10
7
FCB-KM