Rpr/Srp Uplink Card Leds - Cisco CISCO10720 Installation And Configuration Manual

LEDs

RPR/SRP Uplink Card LEDs

Information on both uplink card specific LEDs and system LEDs for the RPR/SRP uplink cards is
located in this section.
The LEDs located on the left side of the RPR/SRP uplink card provide RPR and SRP uplink status
information. See
RPR/SRP uplink card. See
Figure 5-2
10720-SR-LC
Note that the RPR/SRP uplink card uses the label "PROTECT" instead of "WRAP", and the positions of
Note
these two LEDs are different from that on the DPT or POS/DPT uplink card.
Table 5-4
LED
ACTIVE
CARRIER
RX PKT
PASSTHRU
Book Title
5-4
Figure 5-2 and Table 5-4. The system LEDs are located on the right side of the
Table 5-5.
RPR/SRP Uplink Status LEDs
1
RPR/SRP Uplink Status LEDs
Activity Description
Green Port is enabled by software. There is no side mismatch or
loopback.
Amber Loopback is on.
Blinking amber Port is enabled by software and there is a side mismatch. There
is no loopback.
Off Port is not enabled by software
Green Port is up and there is a valid SONET signal without any alarms.
Amber Port is up and there is at least one alarm (LOS, LOF, RDI, and
so on.)
Off Off.
Green Framer is receiving packets.
Off Framer is not receiving packets.
Green Port is in passthrough mode.
Off Port is operating normally.
Chapter 5 Troubleshooting the Uplink Cards
2
CONSOLE AUX
RESET
78-13113-06 B0