Hardware Requirements - Cisco CISCO10720 Installation And Configuration Manual

Preparing for Installation
Installation prerequisites and preparation information for installing an uplink card in a Cisco 10720
router are in the following sections:
•
•
•

Hardware Requirements

Ensure that your equipment configuration meets the minimum requirements for the uplink card
installation and that you have all the parts and tools you need.
To ensure compatibility with the Cisco IOS software, your DPT or POS/DPT uplink card should have a
hardware revision level of 73-05345-03 Rev. A0 or higher. Your RPR/SRP uplink card should have a
hardware revision level of 73-9006-02 Rev. A0 or higher. Determine the hardware revision number by
using the following method:
•
•
78-13113-06 B0
Hardware Requirements, page 2-1
Software Requirements, page 2-2
Safety and Compliance, page 2-3
Hardware label
Read the hardware revision number printed on a label affixed to the component side of the
uninstalled card.
show diags 1 slot command
Use the show diags 1 slot command to identify an installed uplink card. See the following example
to locate the hardware revision for the uplink card. In the example below, see the lines called out in
italic print to indicate where the hardware revision number is located.
Router# show diags 1
SLOT 1:1 one-port OC48 SONET based SRP controller.
TX FPGA ver.:0x0012
RX FPGA ver.:0x0012
RAC A ver...:0x0004
RAC B ver...:0x0004
Framer A ver:0x0006
Framer B ver:0x0006
PCA (73) Item Num:73-05345-03
PCA (73) Item Num - Rev:A0
Fab (28) Ver:3
Unit (800) Item Num:800-09017-02
Unit (800) Item Num - Rev:A0
Serial Number:CAT0532000T
Optical Hardware Configuration:Short Reach (SR)
C H A P T E R
Book Title
2
2-1