Cisco CISCO10720 Installation And Configuration Manual page 67

Chapter 5 Troubleshooting the Uplink Cards
Table 5-4
LED
PROTECT
The LEDs located on the right side of the uplink card provide system status information.
Table 5-5
Note
Table 5-5
LED
OVERTEMP
CARD FAIL
SYSTEM STATUS
POWER
1. System power up is not an indication that the uplink card is powered up. Check the card status LEDs to ensure the card is
functioning properly and is receiving power from the system.
78-13113-06 B0
RPR/SRP Uplink Status LEDs (continued)
Activity
Green
Off
Amber
Blinking green
Blinking amber
also indicates the system status of the card as it initializes.
RPR/SRP Uplink Card System LEDs
Activity
Green (default status
when initialized)
Amber/green
Amber
Amber
Off (default status
when initialized)
Amber
Amber/green
Green (default status
when initialized)
Green (default status
when initialized)
Off
Description
Remote wrap.
No wrap.
Local wrap.
Remote steer.
Local steer.
Description
System is operating within the proper temperature range.
o o
(inlet <104 F [40 C]; outlet <109
Both LEDs are on, (appears orange). System is working
on warning temperature range.
o o
(104 F [40 C] <= inlet < 122
o o
109 F [43 C] <= outlet < 127
System is working on critical temperature state.
o o
(122 F [50 C] <= inlet < 149
o o
127 F [53 C] <= outlet < 167
A hardware failure is detected on the uplink card. During
power up, the LED will be amber even when the uplink
card is powered down.
Card is operational. The LED is turned off after hardware
initialization.
Not applicable.
Both LEDs are on (appears orange). This is the normal
configuration during power up. Once the software loads
successfully, the amber LED will turn off.
System is operational.
Uplink card is receiving power from the system.
Uplink card is not receiving power from the system.
LEDs
o o
F [43 C])
o o
F [50 C],
o o
F [53 C])
o o
F [65 C],
o o
F [75 C])
1
Book Title
5-5