National Instruments PXIe-5663E Getting Started page 11

product before connecting cables and employ industry-standard ESD
prevention measures during installation, maintenance, and operation.
Figure 3. NI 5663E Front Panel Interconnection
1. Medium, Semi-Rigid SMA-to-SMA Cable, Labeled C
2. Flexible SMA-to-SMA Cable
3. Short, Semi-Rigid SMA-to-SMA Cable, Labeled D
4. 50 Ω Termination Load
1. Using the center pin of a medium semi-rigid SMA-to-SMA cable labeled C,
connect the RF OUT connector on the NI 5652 LO source front panel to the
LO IN connector on the NI 5601 RF downconverter front panel.
2. Using the center pin of a flexible SMA-to-SMA cable, connect the REF OUT2
connector on the NI 5652 LO source front panel to the CLK IN connector on the
NI 5622 IF digitizer front panel.
3. Using the center pin of a short semi-rigid SMA-to-SMA cable labeled D,
connect the IF OUT connector on the NI 5601 front panel to the IF IN connector
on the NI 5622 IF digitizer front panel.
RF Signal Generator RF Downconverter 16-Bit IF Digitizer
ACCESS
ACCESS ACTIVE ACCESS ACTIVE
500 kHz - 6.6 GHz 10 MHz – 6.6 GHz
IF IN
RF IN
RF OUT
50 Ω
+20 dBm MAX +20 dBm MAX
0.5 W [+30 dBm MAX 50 Ω
MAX
w/Attenuation]
Reverse
Power
IF OUT
1
+20 dBm MAX
REF IN/OUT
CLK IN
LO IN
50 Ω
IN:
5 Vp-p
MAX
OUT:
0 dBm NOM
1 Vp-p
+20 dBm MAX
CLK OUT
LO OUT
REF
2
OUT2
50 Ω
0 dBm NOM
1 Vp-p
ALL PORTS
ESD
±5 VDC MAX
SENSITIVE
50 Ω
PXIe-5663E Getting Started
ACTIVE
3
PFI 1
TTL
6.3 Vp-p
MAX
50 Ω
2 Vp-p
NOM
4
50 Ω
11
© National Instruments