Specifications; Troubleshooting - Qtx QTFX-LBF1 User Manual

Channel Value
CH1 0-255
CH2 0-255
CH3 0-255
CH4 0-255
CH5 0-255
CH6 0-255
CH7 0-255
CH8 0-255
CH9 0-130
131-255
CH10 0-255

Specifications:

Power supply
Fuse rating
Power
DMX channels
Warm up time
Remote control frequency
Fog output (approx.)
Tank capacity
Number of wheels
Number of wands per wheel
LED power
Dimensions
Weight

Troubleshooting:

No power to main unit
or wired controller
Power to unit but no
haze/bubble output in
manual or continuous
mode
www.avsl.com
Content
Fog effect (low to high)
Bubble effect (low to high)
Bubble height and fan speed increase
Bubble volume and fan speed increase
Red LED (low to high)
Green LED (low to high)
Blue LED (low to high)
Strobe effect (slow to fast)
Colour change mode
Colour fade mode
Colour change/fade mode speed adjust (slow to
fast)
220-240Vac, 50/60Hz (IEC)
F5A
900W
10CH
3-5 minutes
433Mhz
5,000 cu.ft per minute
1.2 litres (fog)
1
10
12 x 1W RGB
550 x 255 x 315cm
6.7kg
Check mains voltage is correct and socket is switched on
Check IEC lead is OK and connected properly
Check mains fuse in IEC connector and fuse in plug top
If fuse blowing repeatedly, refer to qualified service personnel
Check fluid level in tank/reservoir
If fluid is OK and pump working, the lines may be blocked
Check that output is not set to zero on the control panel
Check that output is not switched off on the keyfob remote
If blocked, clean with cleaner & distilled water
Check that if DMX mode is selected, the DMX channel is correct
In DMX mode, check that haze output is not set to zero
160.555UK Manual