Hand Held Products IK8560 User Manual page 61

Enabling the Aimer
The 5100SR/SF engine contains a green aiming beam that is enabled by default in the Scan Demo. To enable the aiming beam,
tap Setup > Enable Aimer. A checkmark appears on the menu to indicate that the aiming beam is enabled.
To see the aiming beam, see Omni-Directional Aiming on page 6-2.
Auto-Send
Auto-send allows you to send decoded information over a TCP/IP connection–both wired and wireless–to a workstation.
1. Enter the TCP/IP parameters by tapping Setup > Radio Frequency.
2. Use the SIP to enter the IP Address of the receiving workstation.
3. Verify that the default TCP Port of 6000 is correct.
4. Tap Close to save.
5. Tap Setup > Auto-Send. The next bar code you decode will be sent over the TCP/IP connection.
Image Kiosk 8560/8570 User's Guide Rev B 6 - 7
3/1/07