Razor W15127016043 Replacement Procedure

Download this manual

Required Tools: (Not included)

A. Phillips screwdriver

B. 2 mm Allen wrench

C. Flat screwdriver

WARNING

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these

steps in the correct order may cause irreparable damage.

Step 1

Using a Phillips screwdriver, remove five (5) screws from

the battery cover on the charger port side.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.

UB1 THROTTLE - REPLACEMENT PROCEDURE

Step 2

Remove two (2) more screws from the other side of the

battery cover. Remove battery cover and set aside.

PART # W15127016043

Page 1 Remove two (2) more screws from the other side of the the battery cover on the charger port side. battery cover. Remove battery cover and set aside. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 2 WD40 or soapy water to help ® remove the grip. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 3 Reverse steps for re-assembly. Step 9 Reverse the steps. ATTENTION: Charge battery 5 hours before using. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.

Ub1