Advertisement
Required Tools: (Not included)
A. Phillips screwdriver
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Step 1
Using a Phillips screwdriver, remove ten (10) screws from
the bottom of the unit.
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
ELECTRIC PARTY POP/ELECTRIC TEKNO
BATTERY INSTALLATION
REPLACEMENT PROCEDURES
Step 2
Flip the unit over and lift the deck being careful not to pull
the wires from the sensor pad. Set the deck cover aside.
PART # W13111701003
1
Advertisement
Table of Contents
Related Manuals for Razor W13111701003
Summary of Contents for Razor W13111701003
- Page 1 Flip the unit over and lift the deck being careful not to pull the bottom of the unit. the wires from the sensor pad. Set the deck cover aside. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
- Page 2 Step 5 Reverse the steps. ATTENTION: Charge battery 4 hours before using. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Need help?
Do you have a question about the W13111701003 and is the answer not in the manual?
Questions and answers