Razor W15155049003 Battery Replacement Procedure

Download this manual

Required Tools: (Not included)

A. Phillips screwdriver

B. 4 mm Allen wrench

WARNING

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these

steps in the correct order may cause irreparable damage.

Step 1

Using a Phillips screwdriver, remove nine (9) screws from

the bottom of the deck.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.

BATTERY REPLACEMENT PROCEDURES

Step 2

Using a 4 mm Allen wrench, remove two (2) hex screws.

One on each side of the deck.

POWER A2

PART # W15155049003

Page 1 Using a 4 mm Allen wrench, remove two (2) hex screws. the bottom of the deck. One on each side of the deck. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 2 Remove the controller cover to access the wires. and pull the bracket out of the frame. Remove the grommet at the back of the tray. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 3 Line up the wires and slide battery tray back inside the to controller. frame. Reposition the grommet at the back of the tray. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 4 Reconnect throttle to controller and place the grommet Secure the bracket to frame. Place the plastic cover back back into the bracket. onto the unit. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 5 Step 15 Step 16 Reposition controller cover and secure with screws. Reverse the steps. ATTENTION: Charge battery 10 hours before using. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.