Razor POWER CORE E90 Replacement Procedures

Sprint power switch

Hide thumbs Also See for POWER CORE E90:

Required Tools: (Not included)

A. Phillips screwdriver

B. Flat screwdriver

WARNING

CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect

charger before conducting any assembly or maintenance procedures. Failure to follow these

steps in the correct order may cause irreparable damage.

Using a Phillips screwdriver, remove the five (5) screws

from the side with the power switch.

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.

POWER CORE E90 SPRINT POWER SWITCH

REPLACEMENT PROCEDURES

Pull the cover off. Be careful not to damage the wires for

the charger port and power switch. Set cover aside.

PART # W13111401101

Table of Contents

Need help?

Do you have a question about the POWER CORE E90 and is the answer not in the manual?

Page 1 Pull the cover off. Be careful not to damage the wires for from the side with the power switch. the charger port and power switch. Set cover aside. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
Page 2 Step 5 Reverse the steps. ATTENTION: Charge battery 12 hours before using. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.

W13111401101