Razor W13112130043 Replacement

Razor W13112130043 Replacement

Throttle for black label e90, black label e100

Advertisement

Quick Links

Required Tools: (Not included)
A. Flathead screwdriver
B. 5 mm Allen wrench
C. 3 mm Allen wrench
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.

Step 1

Using a 5 mm Allen wrench loosen up the bolts from the
collar clamp and remove the t-bar.
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
BLACK LABEL E90™/BLACK LABEL E100™
THROTTLE REPLACEMENT

Step 2

Disconnect the throttle from the controller.
PART # W13112130043
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the W13112130043 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Razor W13112130043

  • Page 1 Using a 5 mm Allen wrench loosen up the bolts from the Disconnect the throttle from the controller. collar clamp and remove the t-bar. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
  • Page 2 Set end cap aside. Step 7 Reverse the steps to install. ATTENTION: Charge battery 12 hours before using. Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.

Table of Contents