Respekta AC179IX Instructions For Use Manual page 34

4. Maintenance and care of the appliance
4.1 Overall cleaning
0 Dusts behind the refrigerator and on the ground shall be timely cleaned to improve the cooling effect and
energy saving.
0 Check the door gasket regularly to make sure there are no debris. Clean the door gasket with a soft cloth
dampened with soapy water or diluted detergent.
0 The interior of the refrigerator should be cleaned regularly to avoid odor.
9 Please turn off the power before cleaning interior, remove all foods, drinks ,shelves, drawers, etc.
0 Use a soft cloth or sponge to clean the inside of the refrigerator, with two tablespoons of baking soda and
a quart of warm water. Then rinse with water and wipe clean. After cleaning, open the door and let it dry
naturally before turning on the power.
0 For areas that are difficult to clean in the refrigerator (such as narrow sandwiches, gaps or corners), it is
recommended to wipe them regularly with a soft rag, soft brush, etc. and when necessary, combined with
some auxiliary tools (such as thin sticks) to ensure no contaminants or bacterials accumulation in these
areas.
0 Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may cause odors in the interior of
the refrigerator or contaminated food.
0 Clean the bottle frame, shelves and drawers with a soft cloth dampened with soapy water or diluted
detergent. Dry with a soft cloth or dry naturally.
0 Wipe the outer surface of the refrigerator with a soft cloth dampened with soapy water, detergent, etc., and
0 Do not use hard brushes, clean steel balls, wire brushes, abrasives
0 Do not rinse directly with water or other liquids during cleaning to
then wipe dry.
(such as toothpastes), organic solvents (such as alcohol, acetone, I
banana oil, etc.), boiling water, acid or alkaline items, which may 1 __ 1
damage the fridge surface and interior. Boiling water and organic \_;§ 8* I
solvents such as benzene may deform or damage plastic parts. §} @_ §~
:24' i : i 1 > W'
Q Q
avoid short circuits or affect electrical insulation after immersion.
C A Please unplug the refrigerator for defrost and cleaning.)
4.2 Cleaning of door tray
9 According to the direction arrow in the figure below, use both hands to squeeze the tray,
and push it upward, then you can take it out.
' After washing the tray having been taken out, you can adjust its installing height
in accordance with your requirement.
T l
(The picture above is only for reference. The actual configuration will depend on
the physical product or statement by the distributor)
13