Product Information; Models; Certification - ORTAL 44HH Series Installation And Operation Manual

Product Information

Models

HH models are supplied with a double glass heat barrier option only. A screen heat barrier is not
available for HH models.
Series Models
44HH Front
44HH RS
44HH
44HH LS
44HH TS
NOTES:
For more information on Power Venting, please refer to the Power Vent System Installation and Operation Manual.

Venting is not supplied by Ortal with the fireplace. The fireplace is certified to be used with, and can be obtained from, the

vent manufacturers outlined in "General Venting Requirements" section on page 28.

Certification

44HH series fireplaces have been tested and approved by CSA Group for safety and efficiency for use with Natural Gas (NG) and
Propane (LP) only, and NOT for use with solid fuels.
CSA Group is approved by the American National Standards Institute (ANSI) as an Accredited Standards Developer.
Certification Standard:
US: ANSI Z21.88 – 2019: Vented Gas Fireplace Heaters
Canada: CSA 2.33 – 2019: Vented Gas Fireplace Heaters
Products:
CLASS 2901 84: DOMESTIC HEATERS (GAS) Vented Fireplace: Certified to US Standard
CLASS 2901 04: DOMESTIC HEATERS (GAS) Vented Fireplace
The fireplaces are permitted for indoor use only. "Indoor" is defined as a conditioned space. The fireplaces are not approved for
outdoor or partial outdoor installation. The fireplaces must be installed while maintaining required clearances. Installation is
recommended in living spaces such as bedrooms, living rooms, great rooms, etc. The fireplaces are not approved for closet
installation. The fireplace must be installed according to Ortal requirements in addition to any local codes that may apply, such as
USA: ANSI Z223.1/NFPA 54, Canada: CSA B149.
IMPORTANT:
Consult the authority having jurisdiction to determine the need for a permit prior to starting the installation.

It is the responsibility of the fireplace dealer and installer to ensure that this fireplace is installed and framed in compliance

with these instructions and all applicable codes.
Before starting, take careful note of ALL the WARNINGS in this manual.

Burner Certification Standard
US: ANSI Z21.88-2019
100 Single
Canada: CSA 2.33-2019
Gas Types Direct Venting
Standard
Type: Passive Vent
Vent Size: 5"x8" (co-axial)
Natural Gas
or
Propane
Optional
Type: Power Vent
Vent Size: 3"x5" (co-axial)
5