Nauticam 26350 Instruction Manual

26350 Flash Trigger for Nikon
(Compatible w/ NA-
D5/D500/D850/Z7)
Instruction Manual
F
OREWORD
Thank you for your purchase of a NAUTICAM product.
At NAUTICAM, we pride ourselves in the ability to recognize the
requirements of professional as well as amateur underwater photographers
and fulfill them through the innovative designs of our products. We strive to
achieve a high level of user-friendliness by allowing stress-free installation
and easy operation of all important functions of the camera.
Please read this manual carefully before using the product, this will maximize
its performance as well as its lifetime.
W
ARRANTY
All NAUTICAM Products are warranted against any material and
manufacturing defects for two years from the date of purchase for consumer
use. This warranty only applies to products purchased from authorized
NAUTICAM dealers and does not extend beyond the original retail purchaser.
To return your product for service, please contact your regional authorized
service center(s). Please note that this warranty only applies when the
product is purchased in the territory where the service center is located.
NAUTICAM does not hold responsibility for damage, of any nature, to any
equipment used with and/or placed within our products.
NAUTICAM accepts no liability for any loss of captured images or the inability
to capture images even if it is due to the malfunctioning of our products.
Unauthorized modifications and/or repairs of our products will automatically
invalidate the warranty.
Product photos may differ from actual products.
P
RECAUTIONS
• Use only batteries approved for use in this product, do not mix old and
new batteries.
• Check the battery terminals before installing into the product.
• Remove batteries for storage, do not store the product in an environment
of high humidity.
• Do not leave the product in direct sunlight for prolonged periods.
• Keep out of reach of children, failure to do so could result in injury.
• Defective products should be shipped to our distributors for service,
unauthorized disassembling and/or modifications could result in mal-
function.
I P
DENTIFICATION OF ARTS
Status Indicator
Socket for electric
LED
bulkhead
TTL-converter switch
Battery compartment
Ready Clock
connector
Trigger connector
Ground connector
Socket for electric
bulkhead
TTL Data
connector
connector
TTL on/off
connector
connector
I
NSTALLATION
NA-D5
NA-D500
Remove the original LED flash trigger from the housing by unscrewing the
two screws as indicated above.
Install the TTL converter and simultaneously insert both LEDs into the optical
bulkheads.
ATTENTION: Using any thin long tool (for example a small allen key) to push
both LEDs as deep inside the optical bulkheads as possible. The LED must be
close to the transparent optical element inside the bulkhead to get normal
quality of TTL work, otherwise you will get a wrong exposure of underwater
shots.
Insert CR2032 batteries into battery holders. Before installation check that
"plus" terminal of each battery is in Up position.
Carefully check fiber optical cables. Recommended to use only original
NAUTICAM fiber optical cables. In case of using bad quality or damaged
cables you will get a wrong exposure of underwater shots.
C C
ABLE ONNECTIONS
TTL-Converter maintains synchronization for underwater strobes by
Fiber Optical cable connection and by electric cable connection as well.
Maximum 2 pcs Nauticam Fiber Optic cables can be connected (via
housing optical bulkheads).
IMPORTANT! Nauticam Dual fiber optic cables cannot support reliable
TTL operation at optical bulkheads in this system, because of their
connector construction. Please use only single fiber optic cables.
Maximum 2 pcs Electric cables can be connected (via housing electric
bulkheads).
Dual electric cables ("Sea&Sea", "Ikelite") are supported by system at
each electric bulkhead as well.
Remove
Remove
Current as of 2020-03-16