Veratron VL FLEX 52MM Series User Manual page 12

1. READ THE VL FLEX CONFIGURATION
Launch the "VL Flex Industrial App" and read the actual
configuration of the device by "tapping* the smartphone
onto the front lens.
The READ operation is mandatory before the WRITE
operation is allowed.
After the readout, the App will be set with the current VL Flex
configuration.
NOTE: The antenna position on the smartphone depends on
the model.
Please refer to the smartphone manufacturer manual.
2. SELECT A DISPLAY LAYOUT
Use the section "Layout" to choose whether you want to
display a single or two values on the device.
The preview picture at the top of the app display will update
according to that.
If you choose the dual layout the app expands the settings, so
that both fields can be configured.
3. SELECT THE DATA TYPE
Use the field "Gauge Type" in the section "Data Selection" to
define, which Information should be visible on the VL Flex
display.
The chosen parameters J1939 SPN will be displayed in the
field "SPN" if the parameter has one. If the value of this
parameter is received through the analog input and not
through the J1939 interface, this information isn't significant.
If the dual layout is selected, you can choose the data which
should be displayed on the upper and which on the lower part
of the display.
Note: You can find the complete list of supported datatypes
in the table "Supported Configurations" in this document.
CONFIGURATION
B001026