Projector Control; System Condition; Control Command - FujiFilm FP-Z8000 Owner's Manual

Projector control

It's possible to control the projector by sending commands through the control channel or LAN.
TIP
b
Use FUJIFILM PROJECTOR CONTROLLER for projector control via the control channel or LAN.
FUJIFILM PROJECTOR CONTROLLER is available for download from the sites below.
https://global.fujifilm.com/en/business-optical-devices/projector/fpz8000
(https://global.fujifilm.com/en/business-optical-devices/projector/fpz8000)
When this software is used with FP-Z8000, the firmware version of FP-Z8000 should be
1.06 or later.
FP-Z5000 is not supported.
FP-Z6000 is compatible with Fujifilm projector controllers in all firmware versions.

System condition



Control command


Software specification

System condition
Control channel
Item RS-232C
Connection cable Dsub9
Communication RS-232C Asynchronous , Half-duplex
mode
Baud Rate 115200
Data Length
Parity Check
Stop Bit
Flow Control
Control command
Power
Read/Write Operation
Write Power On
Write Power Off
Read Power Status
Source Selection
HDBaseT
RJ45 （Category 5e
or above）
communication
9600
8 bit
None
1 bit
None
Command (ASCII)
It is effective in the
POWER=ON<CR>
standby state.
POWER=OFF<CR>
In the case of RS-
232C control, It is
effective in any power
state. In the case of
LAN control, It is
GET=POWER<CR> effective only when
the projector is
turned on. [Warming
Up] POWER=OFF2ON
[Cooling Down]
POWER=ON2OFF
LAN
RJ45
TCP: Port23
Remark