Selecting On enables network standby when the projector is in standby mode. The indicator lamps
will flash red.
On
Switch to Normal Standby Mode
Choose how long Enable Network Standby Mode remains on.
Off
20 min
LAN Settings
Adjust network settings.
Press ENTER to display network options and then adjust them as desired. Highlight Apply and
press ENTER to apply changes when settings are complete.
Wired LAN
Option
Status
View network status (display only).
If On is selected, the projector will automatically be detected by
AMX Device Discovery
AMX controllers connected to the current network.
Select On when using the Dynamic Host Configuration Protocol
DHCP
(DHCP). The settings below can be adjusted when Off is selected.
Projector IP Address
Enter an IP address.
Subnet Mask
Enter a sub-net mask.
Default Gateway
Enter the default gateway address.
DNS Server
Enter a DNS server address.
Apply
Press ENTER to apply changes to settings.
MAC Address
View the projector's MAC address (display only).
Options
Off
Options
1 hr
3 hr
Description
6 hr