Udskift hele pakdåsen (fås som reservedel), når der udføres service og vedligeholdelse. Kontakt venligst Danfoss i tilfælde af tvivl. Svejsning Som hovedregel må pakdåsen ikke afmon- For at forhindre, at teflonpakningen i ven- teres, hvis der er indvendigt tryk på ventil- tilsædet og O-ringene mellem ventilhuset...
Page 4
Check that the cone has been fully screwed The valve must be installed with the back towards the bonnet before it is (An Allen key is included in the Danfoss spindle vertically upwards or in horizontal replaced in the valve body (fig. 4).
Page 5
Das Ventilgehäuse muss nach der Ausbau des Ventils empfohlen. Für weitere Informationen Installation frei von Belastungen (externen Den Ventildeckel nicht entfernen, solange wenden Sie sich bitte an Danfoss. Spannungen) sein. das Ventil unter Druck steht. - Kontrollieren, dass der O-Ring (Abb. 9, Temperaturbereich REG-Ventile dürfen nicht in Anlagen...
(une clé allen est incluse dans le jeu de à l’horizontale (figure ). Les vannes tout montage. joints d’étanchéité de Danfoss Industrial doivent être ouvertes manuellement Vérifier que le cône a bien été complète- Refrigeration).